Road To Learning
Teaching and learning resources for the construction industry with NVQ and Diploma Assessment Criteria
Assignment 101 Introduction to Health & Safety in Construction
Assessment 101 Task Test
To complete this assignment the candidate must complete the test.
The test has been designed for each section to be tested in short individual tasks however the method of assessment is at the discretion of the centre i.e. at the end of each section of learning or as an end of course test.
A Pass mark has been allocated for each task and a Pass must be achieved for each task to achieve an overall Pass.
This assignment Test can be achieved at Pass, Merit or Distinction as described in the Marking Criteria.
The total time for this assignment is 1 hours 20mins, each section has its allotted ideal time to be completed in which is shown before each section.
Overall Grading
Pass: 32-35, Merit: 36-39, Distinction: 40-46
Assignment 101 Introduction to Health & Safety in Construction has 12 Task listed below1
Task A1: Health & Safety In Construction
Task A2: The role of the Health & Safety Executive
Task A3: Health & Safety Regulations
Task A4: Responsibility for Health & Safety
Task A5: Slip, Trips & Falls
Task A6: Health & Safety Risks In Construction
Task A7: Risk Assessment
Task A8: Safety Sign Categories
Task A9: Safety Signs
Task A10: Global Harmonized System Level 1
Task A11, A12 : Personal Protective Equipment (P.P.E.)
Additional learning resources for this unit can be found on the following links
